Belle Wig Tutorial

🌟 Crochet patterns needed are below 🌟

Type 3 Beanie Pattern

Belle Bun & Ringlets Instructions for printing

MATERIALS:
#4 weight (worsted) yarn
J-10 (6mm) crochet hook

ABBREVIATIONS
Ch = chain
Dc = double crochet
Rnd = round(s)
Sc = single crochet

STITCH EXPLANATION
Adjustable ring method: Wrap yarn around index finger. Insert hook into ring on finger, yarn over and draw up a loop, then chain 1. Carefully slip ring from finger and work stitches of first round into ring. When first round is complete, gently, but firmly, pull tail to tighten center of ring.

SIZE: Ringlets: About 12 in. (30.5 cm) long
Bun: Circumference is about 6 in. (15 cm)

GAUGE: About 20 sc = 4 in. (10 cm)

RINGLETS (Make 5):
Leaving at least a 3 in. (7.5 cm) tail, ch 60.
Row 1: 3 dc in 3rd ch from hook and in each ch across – 174 dc.
Fasten off, leaving a long yarn tail (at least 3 in./7.5 cm).

BUN:
Make an adjustable ring, then work 5 sc into center of ring.
Rnd 1: Work 2 sc in each st around – you will have 10 sc at the end of this rnd.
Rnd 2: Work *2 sc in next st, sc in next st; rep from * around – 15 sc.
Rnd 3: Work *2 sc in next st, sc in next 2 sts; rep from * around – 20 sc.
Rnd 4: Work *2 sc in next st, sc in next 3 sts; rep from * around – 25 sc.
Rnd 5: Work *2 sc in next st, sc in next 4 sts; rep from * around – 30 sc.
Rnds 6-10: Work sc in each st around.
Fasten off. Weave in ends.

Share the magic!
Share on Facebook112Pin on Pinterest0Tweet about this on TwitterEmail this to someoneShare on Tumblr0Share on LinkedIn0Share on Google+0Share on Reddit0